Here are pics of my finished K9. These pics were taken before it was put on the remote control car that I have. Unfortunately, the remote control car isn't very powerful, so when I tried to test it out in the woods at a festival, it wouldn't drive over the leaves that were on the ground. So, I'm going to have to find a more powerful and hopefully all terrain remote control car for it to go on. These pics also don't show the tail extended.
The body, head, K9, and control pad on top are all made from foam board put together with duct tape and painted. The tail is a telescoping marshmallow roasting stick with the forked end broken off and a cap from a colored pencil glued on the end. The ears are plastic window screen that I glued to heavy duty wire and painted. The nose is a nut and bolt painted black. The eyes are red vinyl and I made the top of the head hinged so I could put an LED bulb with battery inside so the eyes would light up. The neck is dryer hose and the collar, which I took liberty with, is a plastic bracelet with fake rhinestones.
The body, head, K9, and control pad on top are all made from foam board put together with duct tape and painted. The tail is a telescoping marshmallow roasting stick with the forked end broken off and a cap from a colored pencil glued on the end. The ears are plastic window screen that I glued to heavy duty wire and painted. The nose is a nut and bolt painted black. The eyes are red vinyl and I made the top of the head hinged so I could put an LED bulb with battery inside so the eyes would light up. The neck is dryer hose and the collar, which I took liberty with, is a plastic bracelet with fake rhinestones.